Char-Broil 4984619 User's Guide Page 10

  • Download
  • Add to my manuals
  • Print
  • Page
    / 32
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 9
VERY IMPORTANT: Burner venturi must be attached with orifice
holder properly. see illustration below.
We suggest three ways to clean the burner tubes. Use the one
easiest for you.
(A) Bend a stiff wire (a light weight coat hanger works well)
into a small hook. Run the hook through each burner
venturi tube several times.
(B) Use a narrow bottle brush with a flexible handle (do not
use a brass wire brush), run the brush through each
burner venturi tube several times.
(C) Wear eye protection: Use an air hose to force air into
the burner tube and out the burner ports. Check each
port to make sure air comes out each hole.
9.
Wire brush entire outer surface of burner to remove food
residue and dirt.
10.
Clean any blocked ports with a stiff wire such as an open
paper clip.
12.
Check burner for damage, due to normal wear and corrosion
some holes may become enlarged. If any large cracks or
holes are found replace burner.
13.
After cleaning put the burner back into the firebox and attach
the electrode wire onto the electrode connector under the
burner.
14.
Place burner into position and reinstall the wing nuts.
15.
Under the firebox, attach the orifice holder with the venturi tube.
Replace the cooking grate.
Correct
engagement
with the screws previous removed.
Reinstall
Screws
NOTE:
Cleaning the Burner Assembly
Follow these instructions to clean and/or replace parts of burner
assembly or if you have trouble igniting stove top.
1. Turn gas OFF at control knobs and LP cylinder.
2.
3.
4.
Remove screws that hold orifice holder with the burner
venturi. Figure A
5.
Remove cooking grate.
6.
Remove wing nuts from inside cart to disengage it.
7.
Carefully lift up the burner enough to expose the electrode
Detach wire from electrode underneath the burner
Carefully take out the burner to clean. Figure C
8.
While cleaning, make sure that the ignitor wire is not bent
or broken.
wire.
Figure B
Remove
Screws
NOTE:
Burner Venturi
A
View from under firebox
Remove three Wing Nuts
C
10
from inside cart
B
Page view 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Comments to this Manuals

No comments