Char-Broil T-22D 466270612 User's Guide

Char-Broil Performance T-22DAssembly instructions © 2011 PRODUCT GUIDEMODEL 466270612 © 2011 Char-Broil, LLC Columbus, GA 31902Printed in C

This warranty only applies to units purchased from an authorized retailer. Manufacturer warrants to the original consumer-purchaser only that this pr

PARTS LISTNOTE: Some grill parts shown in the assembly steps may differ slightly in appearance fromthose on your particular grill model. However, the

PARTS DIAGRAM12 ACHIKKLMNWFFXOCCBBAAQ QMLIJJGDFBERSVYZPEEGGTUIIHHJJKKKKJJTDDUMMLL

21/4-20x1/2” screw1Attach side panels to bottom shelf using three 1/4-20x1/2” screws, 7mm lock washers, and 7mm flat washers per panel.7mm lock washer

34This step requires two people to lift and position grill head onto cart. Carefully lower the grill head onto the cart, aligning slots at bottom of g

1556Pull out the two knobs from control panel. Insert temperature gauge stem into the bigger hole above knob bezel, shown A. Make sure the gauge

7ABC16Attach foldable side shelf brackets to the tracks under right side shelf using one shoulder screw, 7mm flat washer, 7mm lock washer and 1/4” nut

817 Fascia, right side shelfInsert flange on right side shelf into side shelf brackets on side of firebox, shown A. Attach rear of shelf using one 1/

10Attach right and Insert left and right grease tray rails into slots left rails under front brace with two #8x3/8” self-tapping screws, shown B. 18R

1112Insert hinge pin on bottom of door into hole in bottom shelf. Press upper hinge pin in front brace, align hinge hole on top of door, and release h

1. Do not store or use gasoline or other flammable liquids or vapors in the vicinity of this or any other appliance.2. An LP cylinder not connected fo

1320Install flame tamers by sliding one end of each flame tamer into slots at front of firebox and resting opposite end on pins in back of firebox.Bac

On back of grill, slide grease tray into opening in upper back panel.CAUTIONFailure to install grease tray will cause hot grease to drip from bottom o

–2217LP CYLINDER IS SOLD SEPARATELY. Fill and leak check the cylinder before attaching to grill and regulator (see Use & Care section). Once cylin

DANGER: If a gas leak cannot be stopped, or a fire occurs due to gas leakage, call the fire department.EmergenciesProblemGas leaking from cracked/cut/

Troubleshooting (continued)ProblemBurner(s) will not light using ignitor.(See Electronic Ignition Troubleshooting also)Burner(s) will notmatch light.

Troubleshooting - Electronic IgnitionProblem (Ignition)SECTION INo sparks appear at any electrodes when Electronic Ignition Buttonis pressed; no noise

NOTES26

27 First Name | Nombre | Prénom Initial | Inicial | Initiale Last Name | Apellido | Nom de FamillieAddress (number & street) | Dirección (número

WARNINGCALIFORNIA PROPOSITION 651. Combustion by-products produced when using this product contain chemicals known to the State of California to cause

• NEVER store a spare LP cylinder under or near the appliance or in an enclosed area. • Never fill a cylinder beyond 80% full.• An over filled or impr

WARNINGIf “growing” bubbles appear do not use or move the LP cylinder. Contact an LP gas supplier or your fire department!Connecting Regulator to the

6.Turn the coupling nut clockwise and tighten to a full stop. The regulator will seal on the back-check feature in the LP cylinder valve, resulting in

Safety TipssBefore opening LP cylinder valve, check the coupling nut for tightness.sWhen grill is not in use, turn off all control knobs and LP cylind

Burner Flame Check• Remove cooking grates and flame tamers. Light burners, rotate knobs from HI to LOW. You should see a smaller flame in LOW position

Cleaning the Burner AssemblyFollow these instructions to clean and/or replace parts of burnerassembly or if you have trouble igniting grill.1. Turn g