Char-Broil C-45G3 463461613 User Manual download pdf (Page 68)

Accessories 68

Mechanical accessories6RWU0-03A

PTAC

2.1 Stamped Aluminum Grille – Single Pack

Outdoor Grilles are attached to the Wall Sleeve and exposed to the exterior Wall. These Grilles comes in industry standard

size of 42" x 16". These Grilles are of two types :

(a) Stamped Aluminum Grille

Installation Procedure:

The Installation and servicing of the equipment should be performed by qualified and experienced personnel only.

(a) Stamped Aluminum Grille.

1) Prepare the wall sleeve for installation of the Grille by removing the cardboard stiffener and rear enclosure panel from the

sleeve. These items may be removed from the inside of the room.

Note: -

The Sleeve stiffener must be taken out before the rear sleeve enclosure panel can be removed from the sleeve.

Stamped Aluminum Grille

AYRGALA01

2. Mechanical Accessories

2) Prepare the stamped Aluminum Grille for installation on the sleeve by inserting the six plastic grommets into the square

holes located near the outer edges of all the four sides of the Grille. Now with the Grille positioned so that the flanges of

all the four sides are in the up position (at 90 degrees), insert the grommets in the opposite direction so that their square

end protrudes through the grille through the flanges. The Grille is installed in such a way that it could be removed through

the rear sleeve opening.

3) Install the stamped Aluminum Grille by aligning the guide

pins located in the lower right and left hand corners of the

Grille with the corresponding holes in the rear of the wall

sleeve.

4) Secure the Grille by threading each of the screws into the

plastic grommets.

5) Remove the wire handle from the center of the grille prior

to installing the chassis into the sleeve.

1 2 ... 63 64 65 66 67 68 69 70 71

No comments

Char-Broil C-45G3 463461613 User Manual Page 68