Natural Gas Conversion Kit 4984625 • •12/20/073497930 NATURAL GAS CONVERSION KITFOR OUTDOOR USE ONLYThis Natural Gas Conversion Kit can be used ONLY
FireboxBurners shown in place. Replace Main Burner Bezels and Control Knobs NOTE: REPLACE ONE BEZEL AT A TIME. DO NOT REMOVE ALL THE BEZELS AT TH
Main Burner Conversion (Cont.)Reinstall LP Tank Heat Sheild - Insert tabs without screw holes(at rear of heat shield) into back panel slots. - Align
1213Natural Gas Hose Conversion6 - Manifold connection is located on the right hand side and toward the front and inside of the cart. - Using a wren
- Open the sideburner cover. Remove the griddle and cooking grate. (Sideburner cover not shown for clarity.) - Pull the sideburner control knob off t
- Remove the ignitor wire from the electrode. Shown in view “A” - Remove the two burner mounting screws and washers from the side shelf pan. Shown in
- Using a Phillips Screwdriver, not provided, remove the 4 sideburner pan screws. - Remove the sideburner pan by lifting it straight up. - At this po
- Install the Sideburner pan with the 4 sheet metal screws removed previously. Tighten screws only enough to secure sideburner pan. Shown A. - Caref
22 - Place side burner wind diverter over side burner aligning cutout - Place burner cap onto side burner and attach side burner cap clip. Shown B. -
Sideburner natural gas bezel8000789423 - FOR SIDEBURNER UNITS: Use bezel part number 80007894. - FOR OUTDOOR STOVE & GRIDDLE UNITS: Use bezel par
EMERGENCIES: If a gas leak cannot be stopped, or a fire occurs due to gas leakage, call the fire department.EmergenciesGas leaking from cracked/cut/bu
DANGERSafety SymbolsThe symbols and boxes shown below explain what each heading means. Read and follow all of the messages found throughout the manual
• Columbus, GA31902 • Assembly Instructions © 2007 •Char-Broil, LLC ®
Connecting Your Grill to the Natural Gas Source. 1. A professionally-installed shut-off valve between the supply piping and the socket is recommended,
Safety TipssWhen grill is not in use, turn off all control knobs and gas source. CAUTIONCAUTION: Sideburner lid must be open when sideburner is in ope
PARTS LIST/DIAGRAMKey Qty. Description Part No.A. . . . . 4 . . . . . Main Burner Natural Gas Bezel. . . . . . . . . . . . . . . . . . . . . . . . .
Main Burner Conversion2Remove Burners - Remove screws from each burner assembly. There are four (4) screws per burner assembly. - Lift each burner ass
3 Install Screws in Burner Venturi Tube - Locate the screw hole in the burner assembly venturi tube. - Install one #8x3/8” self-tapping screw into the
Remove LP Orifices - - Insert the Orifice Driving Tool provided with Kit into the Firebox Burner opening, engage the tool with the orifice, and loos
87 Install Natural Gas (NG) Orifices - Using your fingers, thread the Main Burner NG Orifices into each orifice holder 2-3 turns, clockwise. Do not fu
Comments to this Manuals