Char-Broil 463270910 User's Guide download pdf (Page 17)

First, remove the two screws and lock washers factory attached to the sideburner valve bracket. Position sideburner

valve bracket beneath sideburner shelf fascia so that valve stem comes through larger center hole in fascia. Align the holes

on valve bracket with left and right holes on fascia. Secure using lock washers and screws that were removed from bracket.

Next, place sideburner bezel over valve stem on front side of fascia. Align small holes on bezel with upper and lower holes on

fascia. Attach using two #8-32x3/8" screws and 4ram lock washers. Press sideburner control knob onto valve stem.

Note: Use left and right

holes on fascia to

attach valve bracket

Screws and Washers

removedfrom valve bracket

Note: Use upper and lower

holes on tascla to

attach bezel

Controlknob

) ---..

Sideburner

i valve bracket

!;!;!;!;!;!;!;!;

#8-32x318" screw

Control knob bezel

4mm

lock washer

Valve stem

Pull out the three knobs from control panel, insert temperature gauge stem into the biger hole above knob bezel,shown A.

Make the temperature gauge attached on the panel. Push the temperature gauge downward till it clips on the panel,

shown B/C. Re-install the three knobs. Tern ire gauge stem

Knob

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 27 28

No comments

Char-Broil 463270910 User's Guide Page 17